DS1670 Dual Coating Detector
This NEW dual-purpose detector combines two instruments into one. Use the same device to identify the coated surface of the glass for either the ShowerGuard or DiamondGuard coatings available from Guardian Industries.
Because the specialty coatings are not visible, it is impossible for manufacturers to accurately identify which surface of the glass has the coating without a ShowerGuard or DiamondGuard Detector. With the simple push of a button, processors can confirm they are orienting their glass correctly during their builds.
RC3175 R-CHEK+ Surface Resistivity Meter
Remove all doubt and ensure your product is coated correctly... without breaking the bank! EDTM is proud to offer budget-friendly Four Point Sheet Resistance Meters calibrated to standards that are traceable to a NIST traceable source.
The resistance of a thin film/coating is directly proportional to the resistivity and is a critical QUALITY CONTROL component of a coating. Therefore, resistivity may be the most important factor in determining the repeatability and function of a coating. Sheet resistance has the unit of ohms, but it is convenient to refer to it in ohms per square since the sheet resistance produces the resistance of the coating within any square area. Therefore, this parameter is measured using the 4-point technique.
SG2700 Strengthened Glass Detector
Confirm if your single or double-pane glass has been strengthened.  Strengthened glass can include Heat Strengthened Glass, Tempered Glass, and Safety Glass. It is also sometimes referred to as "Toughened Glass."  Test single or multiple panes - on double-pane glass, you can test both panes at the same time. This is especially helpful with installed windows when one side of the glass is difficult or impossible to get to. It is also much more efficient in the factory - testing on either side offers substantial time savings and is more straightforward than being required to test both sides. Identify the thickness of the first pane of glass.